FS - Lum-Tec Combat B3 #84/150 *$500*

I'm selling my Lum-Tec Combat B3. It is number 84 of a limited run of 150.

I like this watch a lot. It's the perfect size and the lume is incredible. I'm selling to fund the quartz to automatic conversion of my 2007 JSAR. Once complete, I won't have a need for three automatic watches, so this one is on the chopping block.

Comes with all boxes/docs and the Green and Black Zulu straps. Everything you see pictured.

For those that aren't familiar, the specs are below.

43mm Width excluding crown/11.6 mm thick
316L Stainless steel case
Japan Seiko SII NH25A11J Automatic mechanical movement
100 meters / 330 feet water resistance
MDV Lume- Luminous 8-layer dial and hands
Machine brushed finishes
Sapphire crystal
Double side anti-reflective coatings

I believe in full disclosure, so I want to point out that there is a tiny speck of lint/fuzz stuck to the second hand, about 1/3 of the way up the lumed portion of the hand. It is tiny, and may not have been noticed by the buyer, but I want to point it out. I'm sure that Chris at Lum Tec would take care of it no problem, but it never bothered me enough to send it in. As I said, it's tiny. I've done my best to picture it by timing the shot while the second hand was passing the minute or hour hand, but my results are what they are. Otherwise the watch is spotless and keeps great time.

I can send full resolution pictures to buyers if you are hesitant.

Asking $500 Canadian shipped. Firm. I prefer and will favour a Canadian deal, but will ship to the USA.

watches010.jpg


watches015.jpg


watches016.jpg
 
For those concerned with the speck on the second hand, I just received this email from the president of Lum Tec...

Hi,

We can take care of that under warranty. Looks like it could be a flake from the edge of the dial or sapphire gasket. Sometimes things can appear after some time if they are on the side of the dial or in a place that cannot be seen or removed with a dust blower initially. I have attached a service form to send the watch head in for warranty repair.

Best regards,

Chris Wiegand

Nice customer service when the President writes you back directly. So, obviously for those concerned, it is a non issue. I can send the head directly to LumTec and ask them to ship it to you upon completion of the work.
 
Top